Posts Tagged ‘Exhaust’
280ZX – Exhaust & CV Axles
Slightly out of sequence pictures again, but it was easier to show the process this way as I did not take many pictures of the CV install.
The difference is a torsion out of a Subaru WRX STI (R180) Torsion type (3.54). The CV/Flanges are the Wolf Creek Racing kit, I was told when I did this I was the first person to try this in a 280ZX. The only difference was I had to use 240z bolts on one side and 280ZX on the other (wheel side) to make the new CV’s work.
The Exhaust is 3 inches all the way back. I am still trying to source a flange for the 280ZX Stock turbo so I can remove the cast piece.
Pictures Taken May (1-2) & August (remaining) 2016
280ZXR turbo exhaust & undercarriage prior to restore
NOTE: ***This is an out of sequence post***
These pictures were taken just after the turbo engine was installed but before the restore started. You can see some of the rust areas that t I had to focus on when I started my restore.
Photos Taken 11/20/2007
Recent Comments