DoItInADatsun.Com

Here is the new installed a new Palnet fuel rail complete with mounting hardware! Also there I have installed new fuel line fittings (simplified from old setup)  to resolve some leaking issues that I had. The water lines are finally completely hooked up in these photos as well.

What was not photographed between this and the previous update: Heli-Coiled the intake manifold bolt holes. The originals were stripped as a result the intake and exhaust manifolds came on and off a few times during this process. I had re-tapped all the holes but there was not enough left on them to hold at the required torque specifications. Thankfully the heli-coil process went better then expected, and there have not been any issues from this process.

Photos Taken 09/26/2011