Restore
Heat Shrinking/Electrical Cleanup Cont.
December 24, 2013 | 
Author 
Photos Taken: 5/25/2013
280ZX Electrical Cleanup
Wiring cleanup and conversion to heat-shrink for connectors.
Photos Taken: 5/5/2013
Prep – continued
Photos Take: 6/4/2012
Continued Prep
Photos Taken: 5/10/2012
Rust Damage
Some rust damage discovered, and minor progress.
Photos Taken: 4/28/2012
Early degreasing and restore assessment
Hera are some early pictures of the 240z….not in bad shape for its age, but I have found more rust then I would have liked to (not in photos). This is a look at some areas under thethe car that I have started to hand scrub in preparation for repainting/repair.
Photos Taken 04/25/2012
Vacuum lines & new fittings
Here we can see some of the new AN fittings & vacuum lines have been installed. Sadly finding new old stock parts are becoming more and more difficult. This is how the water line ended up with AN fittings which was never a part of my original plans. The end result ended up working out very nicely and has not presented any issues.
Photos Taken 07/15/2011 (First 3) & 7/26/2011 (Last 2)
Tags: 2011, AN Fittings, Fuel Lines, Vacuum Lines, Water Line, West Virginia | 
No Comments »
Engine & New Wiring Harness
Here are some more views of the engine as well as the beginning of the re-installation of my newly refreshed wiring harness. As you can see, not much has changed with the engine in these hew short days minus a few new brackets that were installed. One thing to note is the new fuse box that I utilized from another harness that I was able to fine, the original had its tabs broken off and was in pretty bad shape. The wiring harness was a project that I had been avoiding for some time. The original wires were in bad shape, so I basically made a new engine clip from the existing schematic. It was quite a process that took me a very long time to complete.
Photos Taken 06/22/2011 (First 3) & 6/30/2011 (Last 3)
New Plugs, Intake, & Header
Some pictures of the intake, header, and new plugs installed. This would end up being a “test” fit as there would be issues with the threads on the head that would be discovered later. All over spray that is visible was also removed prior to the final install.
Photos Taken 06/19/2011
More ZXR Engine/Oil Pan repaint Pictures
More pictures of the engine after the repaint, the over spray on the head was removed at a later date. This was a tough job with the engine in the car but it came out pretty nice in the end.
Photos Taken 05/25/2011
Recent Comments